According to informed Chengguan forklift parts , internal combustion forklifts clutch release bearings work frequently, which account for a large proportion of the number of damaged forklift failure, if the driver operating properly, timely maintenance , bearings make this about three months , but in the repair time also new ones .
If the driver of a low technical level , the forklift driver release bearing damage almost every month , the damage will spread to other parts, such as the separation lever and clutch plates , so as equipment maintenance material costs increased significantly.
Methods to extend the life of truck clutch release bearings
Combustion forklifts clutch release bearings work frequently, which account for a large proportion of the number of damaged forklift failure, if the driver operating properly, timely maintenance , bearings make this about three months , but when you have a new one in the repair . If the driver of a low technical level , the forklift driver release bearing damage almost every month , the damage will spread to other parts, such as the separation lever and clutch plates , so as equipment maintenance material costs increased significantly.
It is noted Chengguan forklift parts , clutch release bearings vulnerable reasons Where it? In practice, despite a strict separation of bearings require drivers to drip once a day to oil, which is not only complicated operation , but still often bearing damage . After analysis, due to the high temperature of the engine is transmitted to release bearings , combined with high-speed rotating bearings also generate heat, oil under these conditions remain difficult in the bearings, continuous work under high temperature and poor lubrication conditions , which is frequent causes of damage .
In response to these problems , also experimenting with heating the grease in the bearings , the grease soaked into the bearing , so that after treatment, although can be filled with grease bearings, but because of the grease structure by heat treatment after the destruction of a large performance magnitude lower , using this method is not ideal , does not extend bearing life . We have to use a sharp separation of bearing grease gun nozzle direct injection butter. Re- installed on the car, has been observed to detect , bearing life greatly extended . The oiling method receives a satisfactory result , but the operation is more complex. And then explore the disintegration of the engine is not the case , add the butter , first in 475
Try to obtain a C -type engine is successful, then type in the 475C and 480,492 engines a trial , have received very good results . After repeated practice , improve , lessons learned , and ultimately the formation of a relatively simple oiling method of operation , the specific process is as follows :
(L) non-disintegration of the engine oiling method first open clutch cover , check the wear concept of separation of bearings, bearing no confirmation if damaged or worn no overrun , then remove the clutch pedal , adjust the linkage pivot pin , bearing and the separation seat back to the last position , the bearing bore butter filling with needle nose grease gun until the bearing oil spill , then slightly rotate about bearings, grease again, repeat the above work, a little butter until around the bearing has an overflow , then bearing rotation , observe the oil , if they feel bearing rotation resistance, that they have filled in the bearing grease . Then clear separation of a small amount of spilled everywhere bearing butter, remove the pin and the clutch cover and other re- assembled .
( 2 ) the disintegration of the engine oiling method of separating the engine disintegration exposed bearings and bearing assemblies , to separate the bearing inner ring underneath a small hole with a needle nose grease gun oil , bearing grease overflow when rotating bearing until bearing a circle has a butter overflow can.... |
